Zapi COMBI AC1 Bedienungsanleitung PDF herunterladen (Seite 50)

Page - 50/73 AESZP0BA – AC1 SSL SENSORED - FREE VERSION - User Manual

6) SLIP VALUE

Hz value with two decimal digit. This is the slip between the frequency and

the speed of the motor (SLIP VALUE = FREQUENCY-ENCODER).

7) COSFI

From 0.00 to 1.00. This is a coarse extimation of the Power Factor (cosf

between the voltage and the current in the motor.

8) CURRENT RMS

Ampere value. Root Mean Square value of the line current in the motor.

9) BATTERY CURRENT

Ampere value. This is a coarse calculation (not a measurement) of the

battery current.

10) BATTERY CHARGE

Percentage value. It supplies the residual charge of the battery as a

percentage of the full charge level.

11) TEMPERATURE

°C value. This is the temperature of the inverter base plate. This temperature

is used for the HIGH TEMPERATURE alarm detection (see 14.1.7.1).

12) MOTOR TEMPERATURE

°C value. This is the temperature of the motor windings picked up with an

analog sensor inside the motor. Normally this sensor is a PTC Philips

KTY84-130. This temperature is used only to raise a warning in the hand set

when the motor temperature overtakes the MOTOR OVERTEMP setting.

13) ACCELERATOR

From 0.0V to 5.0V. The voltage on the wiper of the accelerator (CPOT on

CNB#10) is halved inside the controller and then recorded on this reading.

That means the actual wiper voltage is in the range 0 to 10V meanwhile the

corresponding ACCELERATOR reading is in the range 0.0 to 5.0Vdc.

14) BRAKE PEDAL POT

(Standard Version only). From 0.0V to 5.0V. When the MDI-PRC is absent,

the potentiometer connected to CPOTB on CNA#18 is used for a brake pedal

sensor. The voltage on the wiper of this brake pedal potentiometer (CNA#18)

is halved inside the controller and then recorded on this reading. That means

the actual wiper voltage is in the range 0 to 10V meanwhile the

corresponding BRAKE PEDAL POT reading is in the range 0.0 to 5.0Vdc.

15) LIFTING SWITCH

ON/OFF. This is the level of the CNB#9 digital input (Lifting request):

- ON +VB = When CNB#9 is closed to a battery (key) voltage, the

Lifting request is Active.

- OFF GND= When CNB#9 is not connected to a battery (key) voltage

(or it is connected to GND), the Lifting request is not

active.

16) DESCENT SWITCH

ON/OFF. This is the level of the CNB#8 digital input (Lowering request):

- ON +VB = When CNB#8 is closed to a battery (key) voltage, the

Lowering request is Active.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 72 73

Kommentare zu diesen Handbüchern

Keine Kommentare

Zapi COMBI AC1 Bedienungsanleitung Seite 50

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Netzteile und Wechselrichter Zapi COMBI AC1