Zapi AC-2 Wartungshandbuch PDF herunterladen (Seite 15)

- 15/18/20BT-7, 16/18/20B-7 Brake Adjustment.

- Adjusting dimension "A" for the

brake lever is between 0.4 ~ 1.0mm.

-The adjusting dimension has to be checked

with a dial gauge.

- For this purpose position the feeler of the

dial gauge on the brake lever in the specified

measuring point range. Press the brake

lever against the cover and read the

deflection on the dial gauge.

- If the adjusting dimension should not be

within the specified range, it has to be

obtained and set with the pressure pin(5).

- Several pressure pins can be selected.

- If the pressure pin has to be replaced the brake

lever has to be removed again.

- Only then it is possible to replace the pressure

pin from the bore of the cover.

- When installing the pressure pin do not

damage the radial shaft seal. First wet the

sealing lips of the radial shaft seal(6) slightly

with grease before installing the new pin.

- After reinstallation the brake lever, recheck the

adjusting dimension according to the procedure

described above.

Check free play of

brake cylinder during

every maintenance.

If no play, check

handbrake or pedal

brake adjustment.

“A”

For detailed disassembling, assembling and adjustment info: check service manual!!!

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 145 146

Keine Kommentare

Zapi AC-2 Wartungshandbuch Seite 15