Zapi AC-2 Bedienungsanleitung PDF herunterladen (Seite 40)

Page - 40/72 ADEZP0DC - AC-2 FLASH INVERTER - User Manual

Very important:

In the combi system (pump + traction), the battery discharge calculation for

the complete system is carried out by the traction inverter; the information

about the pump inverter consumption is sent on the can-bus line from the

pump inverter to the traction inverter. So the correct programming for the

"Battery check" option is:

- traction inverter: ON

- pump inverter: OFF.

3) SET TEMPERATURE

- DIGITAL: a digital (ON/OFF) motor thermal sensor is connected to F6

input.

- ANALOG: an analog motor thermal sensor is connected between F6

and F12 (the curve can be customized on a customer request).

- NONE: no motor thermal sensor switch is connected.

SUBMENU "ADJUSTMENTS"

1) SET BATTERY TYPE

It selects the nominal battery voltage.

2) ADJUST BATTERY

Fine adjustment of the battery voltage measured by the controller.

3) THROTTLE 0 ZONE

It establishes a deadband in the accelerator input curve (see also curve

below).

4) THROTTLE X POINT

This parameter changes the characteristic of the accelerator input curve.

5) THROTTLE Y POINT

This parameter changes the characteristic of the accelerator input curve.

VACC MIN and VACC MAX are values programmable by the "Program

Vacc" function.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 71 72

Keine Kommentare

Zapi AC-2 Bedienungsanleitung Seite 40